Configure irrigation

Configure irrigation together with the person responsible for the facility’s engineering systems.

1. Check readiness

Make sure the local control node is available, the irrigation system is connected, data sources are selected, and the safety scenario has been agreed.

2. Calibrate the system

Measure the actual flow from one outlet and enter the zone parameters. Calibration is required to convert run time into water volume.

3. Select the main mode

• Time slots — start at specified times;
• By radiation — start after a specified amount of solar energy has accumulated within the configured time window.

Set the dose by time or volume. For radiation mode, select the correct data source and the minimum interval between starts.

4. Configure Safety

The safety schedule should allow the local node to continue safe operation if connectivity or data is lost. It does not replace hardware and emergency protection.

5. Apply the configuration

Review the readiness checklist and explicitly apply the settings. Filling in the fields alone does not change the active configuration until you confirm it.

After applying the settings, monitor actual starts and equipment status. If operation differs from the expected behavior, stop the automatic scenario using the standard procedure and contact the responsible specialist.